HP Visualize J5000 hp Visualize J5000, J7000 workstations owner's guide (a4978 - Page 135
Connecting to the SCSI Ports, System SCSI Port Connection
View all HP Visualize J5000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 135 highlights
SCSI Connections Connecting to the SCSI Ports Connecting to the SCSI Ports This section describes how to connect to the system SCSI ports (Ultra Narrow Single-Ended and Ultra2 Wide Low-Voltage Differential). System SCSI Port Connection The system contains two SCSI connectors: • Ultra Narrow Single-Ended SCSI (NSE SCSI) connector • Ultra2 Wide Low-Voltage Differential SCSI (LVD SCSI) connector The illustration below shows the two SCSI connectors. SCSI cables connect to these ports with a high-density thumbscrew connector. Ultra Narrow Single-Ended SCSI Connector Ultra2 Wide Low-Voltage Differential SCSI Connector NOTE It is necessary to put a terminator on unused SCSI connectors on the back panel, or the last device connected to the SCSI bus. Terminators are shipped with the system. Be sure to use a NSE SCSI terminator for the NSE SCSI bus and an LVD terminator for the LVD SCSI bus. Chapter 7 135