HP Visualize J5000 hp Visualize J5000, J7000 workstations owner's guide (a4978 - Page 78
Installing a Hard Disk Drive into its Tray, remove the grommets; if they are removed
View all HP Visualize J5000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 78 highlights
Figure 3-3 Hot-Pluggable Hard Disk Drives The Disk Drives drive in it, the four screws required to secure the drive to the tray are stored in two tabs on the tray (see illustration below). Remove these four screws from the storage tabs. Installing a Hard Disk Drive into its Tray NOTE Screw-storage tab Grommets (do not remove) Release lever Screw-storage tab Release hook 4. Insert these four screws through the rubber grommets and into the corresponding holes in the disk drive, and tighten them with a T15 Torx driver. There are four rubber grommets, although only two are visible in the illustration above. Do not remove the grommets; if they are removed, the drive would not be held securely in the tray and may be damaged as a result. Once the disk drive is installed into the drive tray, the assembly can be inserted into the desired hard-drive slot. 78 Chapter 3