Pfaff creative 2140 Owner's Manual - Page 26

i'% Rotating Use this icon to you can rotate your design in steps of 50 in the direction of the arrow. Thread tension )j( You can adjust the thread tension (tighter or slacker) with the +1- icons. Ei Repositioning If you rotate a design and it then protrudes beyond the hoop, a red line appears in place of the hoop. This line alerts you to the fact that the design cannot be embroidered in this position. The design is automatically placed into the embroidering field with this function. Undo This function cancels the command described above and places the design back outside the hoop. allowing you to continue turning it. If no red line is visible, a design is within the hoop and can be embroidered. Positioning With this function, you open a window for positioning your design within the hoop. Dialogue window: Using the arrows you can displace the design within the hoop. The numbers at the upper edge of the window show you how far (in mm) your design is displaced from the center of the hoop. Enlarged representation With this function, you obtain an enlarged representation of the design on the screen, as upon design selection. By touching "esc" you switch back to the previous screen, without saving the changes. Embroidery I card - Embroidery alphabets If you select "Alphabets" in Embroidery/card. the processing screen for the embroidery combination is opened. Therefore the available icons are displayed in the same colors as for the embroidery combination. The following icons, which are displayed in the same colors as the embroidery combination. only appear when "Alphabets' is selected. Activity arrows Using these arrows you can scroll through the screen. Zoom up You can enlarge the representation in several steps. The zone around the marked letter or letter combination is the area that is enlarged. Zoom down You can reduce the representation in several steps. The zone around the marked letter or letter combination is the area that is reduced. Marking In order to process a design, it must be marked. You can mark a letter or letter combination. A red dash appears for this purpose: you can move it across the letters to be marked with the cursor icons. The marked letter or letter combination is surrounded by a colored frame. If you move over a previously marked letter or letter combination, the marking is cancelled again. The representation turns black. Deleting You can delete a previously marked letter or letter combination. More functions for embroidery combination By touching this icon you can call up further functions for processing or modifying the design. Touch the icon a further time to close the window.