D-Link DMS-3130 User Manual - Page 154

DMS-3130 Series Multi-Gigabit L3 Stackable Managed Switch Web UI Reference Guide After clicking the Add Rule button next to an Ethernet-IP type profile, the following page will appear. Figure 5-44 VLAN Mapping Profile (Ethernet-IP, Add Rule) Window The fields that can be configured are described below: Parameter Rule ID Src-MAC Address Dst-MAC Address Priority Inner VID Ethernet Type Src-IP Address Dst-IP Address DSCP Source Port Destination Port IP Protocol Action Description Enter the VLAN mapping rule ID here. If not specified, the rule ID begins from 10 and is incremented by 10 for every new rule. The range is from 1 to 10000 Enter the source MAC address here. Enter the destination MAC address here. Select the 802.1p priority value here. The range is from 0 to 7. A higher value has a higher priority. Enter the inner VLAN ID here. The range is from 1 to 4094. Enter the Ethernet type value here. The range is from 0x0 to 0xFFFF. Enter the source IPv4 address and subnet mask here. Enter the destination IPv4 address and subnet mask here. Enter the differentiated services code point (DSCP) value here. The range is from 0 to 63. Enter the source TCP/UDP port number here. The range is from 1 to 65535. Enter the destination TCP/UDP port number here. The range is from 1 to 65535. Enter the Layer 3 IP protocol value here. The range is from 0 to 255. Select the action that will be taken here. Options to choose from are Dot1qTunnel and Translate. • Dot1q-Tunnel - Specifies that the outer-VID will be added for matched packets. 143