D-Link DMS-3130 User Manual - Page 206

DMS-3130 Series Multi-Gigabit L3 Stackable Managed Switch Web UI Reference Guide Figure 5-89 LLDP Dot3 TLVs Settings Window The fields that can be configured are described below: Parameter Unit From Port - To Port MAC/PHY Configuration/Status Link Aggregation Maximum Frame Size Power Via MDI Description Select the Switch unit that will be used for this configuration here. Select the appropriate port range used for the configuration here. Select this option to enable or disable the MAC/PHY Configuration/Status TLV to send. The MAC/PHY Configuration/Status TLV is an optional TLV that identifies (1) the duplex and bit-rate capability of the sending IEEE 802.3 LAN node, and (2) the current duplex and bit-rate settings of the sending IEEE 802.3 LAN node. Select this option to enable or disable the Link Aggregation TLV to send. The Link Aggregation TLV indicates contains the following information. Whether the link is capable of being aggregated, whether the link is currently in an aggregation, and the aggregated port channel ID of the port. If the port is not aggregated, then the ID is 0. Select this option to enable or disable the Maximum Frame Size TLV to send. The Maximum Frame Size TLV indicates the maximum frame size capability of the implemented MAC and PHY. Enable or disable power management between network devices and connected media endpoints through LLDP power with media dependent interface (MDI). Click the Apply button to accept the changes made. LLDP-MED Port Settings The LLDP-MED Port Settings page is used to enable or disable outbound LLDP advertisements for LLDP-MED TLVs. To view the following window, click L2 Features > LLDP > LLDP-MED Port Settings, as shown below: 195