D-Link DMS-3130 User Manual - Page 426

DMS-3130 Series Multi-Gigabit L3 Stackable Managed Switch Web UI Reference Guide To view the following window, click OAM > CFM > CFM Loopback Test, as shown below: Figure 10-14 CFM Loopback Test Window The fields that can be configured are described below: Parameter MAC Address Remote MEPID MEPID MA Name Domain Name LBMs Number LBM Payload Length LBM Payload Pattern PDU Priority Description Select and enter the destination MAC address here. Select and enter the remote MEP ID here. The range is from 1 to 8191. Enter the MEP ID that will initiate the loopback test here. The range is from 1 to 8191. Enter the MA name here. This name can be up to 22 characters long. Enter the MD name here. This name can be up to 22 characters long. Enter the number of LBMs to be sent here. The range is from 1 to 65535. By default, this value is 4. Select and enter the payload length of the LBM to be sent here. The range is from 0 to1500. By default, this value is 0. Select and enter the LBM payload pattern here. This specifies an arbitrary amount of data to be included in a Data TLV, along with an indication whether the Data TLV is to be included. This string can be up to 1500 characters long. spaces are not allowed. Select the 802.1p priority to be set in the transmitted LBMs here. If not specified, it uses the same priority as the CCMs sent by the MA. The range is from 0 to 7 and none. Select the None option to use the default setting. Click the Apply button to accept the changes made. The CFM Loopback Test Result screen will be displayed. CFM Linktrace Settings This window is used to display and configure the CFM linktrace settings. 415