D-Link DMS-3130 User Manual - Page 431
Ethernet OAM
View all D-Link DMS-3130 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 431 highlights
DMS-3130 Series Multi-Gigabit L3 Stackable Managed Switch Web UI Reference Guide • NA - No cable was found, maybe it's because cable is out of diagnosis specification or the quality is too bad. Ethernet OAM Ethernet OAM Settings This window is used to display and configure the Ethernet Operations, Administration, and Maintenance (OAM) settings. To view the following window, click OAM > Ethernet OAM > Ethernet OAM Settings, as shown below: Figure 10-22 Ethernet OAM Settings Window The fields that can be configured in Ethernet OAM Settings are described below: Parameter Unit From Port - To Port State Mode Description Select the Switch unit ID that will be used here. This option is only available if stacking is enabled. Select the Switch port range that will be used here. Select to enable or disable the Ethernet OAM feature on the specified port(s) here. After enabling this function on the interface, the interface will start OAM discovery. If the OAM mode of this interface is active, it initiates the discovery. Otherwise, it reacts to the discovery received from the peer. Select the Ethernet OAM mode here. Options to choose from are Active and Passive. The following two actions are allowed by ports in the active mode but disallowed by ports in the passive mode. (1) Initiate OAM discovery. (2) Start or stop remote loopback. 420