D-Link DMS-3130 User Manual - Page 474

DMS-3130 Series Multi-Gigabit L3 Stackable Managed Switch Web UI Reference Guide Parameter Port Timeout Length ToS Frequency Source IPv4 Address Probe Number Description Enter the port number here. The value range is from 1 to 65535. Enter the timeout period while waiting for a response from the remote device here. A value of 1 to 65535 seconds can be specified. The default is 5 seconds. Enter the length value here. This specifies the number of bytes of the outgoing datagram. The range is from 1 to 1420 bytes. Enter the ToS value here. This specifies the ToS to be set in the IP header of the outgoing datagram. The range is from 0 to 255. Enter the time interval between each probe packet. The range is from 0 to 86400 and the default is 0. Enter the source IPv4 address here. The specified IPv4 address must one of the IPv4 addresses configured for the Switch. Enter the probe time number here. The range is from 1 to 1000. If unspecified, the default value is 1. Click the Start button to initiate the route trace for each individual section. The fields that can be configured in IPv6 Trace Route are described below: Parameter IPv6 Address Domain Name Initial TTL Max TTL Port Timeout Length Frequency Source IPv6 Address Probe Number Description Select and enter the IPv6 address of the destination here. Select and enter the domain name of the destination here. Enter the initial Time-To-Live (TTL) value here. The range is from 1 to 255. Enter the Time-To-Live (TTL) value of the trace route request here. This is the maximum number of routers that a trace route packet can pass. The trace route option will cross while seeking the network path between two devices. The range for the TTL is 1 to 255 hops. Enter the port number here. The value range is from 1 to 65535. Enter the timeout period while waiting for a response from the remote device here. A value of 1 to 65535 seconds can be specified. The default is 5 seconds. Enter the length value here. This specifies the number of bytes of the outgoing datagram. The range is from 1 to 1420 bytes. Enter the time interval between each probe packet. The range is from 0 to 86400 and the default is 0. Enter the source IPv6 address here. The specified IPv6 address must one of the IPv6 addresses configured for the Switch. Enter the probe time number here. The range is from 1 to 1000. If unspecified, the default value is 1. Click the Start button to initiate the route trace for each individual section. After clicking the Start button in IPv4 Trace Route section, the following IPv4 Trace Route Result section will appear: 463