D-Link DMS-3130 User Manual - Page 472

DMS-3130 Series Multi-Gigabit L3 Stackable Managed Switch Web UI Reference Guide Parameter Source IPv4 Address Description Enter the source IPv4 address. If the current Switch has more than one IP address, you can enter one of them to this field. When entered, this IPv4 address will be used as the packets' source IP address sent to the remote host, or as primary IP address. Click the Start button to initiate the Ping Test for each individual section. The fields that can be configured in IPv6 Ping are described below: Parameter Target IPv6 Address Domain Name Ping Times Timeout Frequency Length Stop Time Source IPv6 Address Description Enter an IPv6 address to be pinged. Select and enter the domain name of the system to discover. Enter the number of times desired to attempt to Ping the IPv6 address configured in this window. Users may enter a number of times between 1 and 255. Tick the Infinite check box to keep sending ICMP Echo packets to the specified IPv6 address until the program is stopped. Select a timeout period between 1 and 99 seconds for this Ping message to reach its destination. If the packet fails to find the IP address in this specified time, the Ping packet will be dropped. Enter the time interval between each Internet Control Message Protocol (ICMP) request. The range is from 0 to 86400 and the default is 0. Enter the length value here. This specifies the number of data bytes to send. The default value is 56, which translates into 64 ICMP data bytes when combined with the 8 bytes of ICMP header data. It does not include any VLAN or IEEE 802.1Q tag length. The range is from 1 to 1452 bytes. Enter the stop time value here. This specifies to stop the ping after the number of times entered here. If this value is configured as 0, then the ping can only be stopped by clicking the Stop button manually. The range is from 0 to 99. Enter the source IPv6 address. If the current Switch has more than one IPv6 address, you can enter one of them to this field. When entered, this IPv6 address will be used as the packets' source IP address sent to the remote host, or as primary IP address. Click the Start button to initiate the Ping Test for each individual section. After clicking the Please Select button, the following window will appear: Figure 13-13 Ping (Please Select) Window Select the radio button next to the entry to use that ACL in the configuration. Enter a page number and click the Go button to navigate to a specific page when multiple pages exist. Click the OK button to accept the selection made. 461