D-Link DXS-3610 User Manual - Page 140

DXS-3610 Series Layer 3 Stackable 10GbE Managed Switch Web UI Reference Guide Parameter Ether Type Description Enter the Ethernet type value for the group here. The protocol value is used to identify a protocol of the frame type specified. The range is from 0x0 to 0xFFFF. Depending on the frame type, the octet string will have one of the following values:  For Ethernet 2, this is a 16-bit (2-octet) hex value. For example, IPv4 is 0800, IPv6 is 86DD, ARP is 0806, etc.  For IEEE802.3 SNAP, this is a 16-bit (2-octet) hex value.  For IEEE802.3 LLC, this is a 2-octet IEEE 802.2 Link Service Access Point (LSAP) pair. The first octet is for Destination Service Access Point (DSAP) and the second octet is for Source. Click the Apply button to accept the changes made. Click the Delete button to remove the specific entry. Protocol VLAN Profile Interface This window is used to display and configure the protocol VLAN profile interface settings. To view the following window, click L2 Features > VLAN > 802.1v Protocol VLAN > Protocol VLAN Profile Interface, as shown below: Figure 5-20 Protocol VLAN Profile Interface Window The fields that can be configured are described below: Parameter Port Profile ID VID Priority Description Select the stacking unit ID and the port number of the Switch that will be configured here. Select the 802.1v protocol VLAN profile ID here. Enter the VLAN ID used here. Select the priority value used here. The range is from 0 to 7. This parameter is specified to rewrite the 802.1p default priority previously set in the Switch, which is used to determine the CoS queue that packets are forwarded to. Once this field is specified, packets accepted by the Switch that match this priority are forwarded to the CoS queue specified previously. Click the Apply button to accept the changes made. Click the Delete button to remove the specific entry. 129