D-Link DXS-3610 User Manual - Page 590

DXS-3610 Series Layer 3 Stackable 10GbE Managed Switch Web UI Reference Guide Parameter Remote Loopback Description  Process - Specifies to react to remote loopback requirements from a peer. The feature is used to configure the client to process or to ignore the received Ethernet OAM remote loopback feature. In the remote loopback mode, all user traffic will not be processed. Ignoring the received remote loopback feature will prevent the port from entering the remote loopback mode. Select the remote loopback action here. Options to choose from are:  Start - Specifies to request the peer to change to the remote loopback mode.  Stop - Specifies to request the peer to change to the normal operation mode. If the remote peer is configured to ignore the remote loopback request, then the remote peer will not enter or exit the remote loopback mode upon receiving the request. To start the remote peer to enter the remote loopback mode, administrators must ensure that the local client is in the active mode and the OAM connection is established. If the local client is already in the remote loopback mode, then this feature cannot be applied. Click the Apply button to accept the changes made. The fields that can be configured in Ethernet OAM Table are described below: Parameter Unit From Port - To Port Description Select the Switch unit ID that will be used here. Select the Switch port range that will be used here. Click the Find button to locate a specific entry based on the information entered. Click the Show All button to display all the entries. 579