D-Link DXS-3610 User Manual - Page 396

DXS-3610 Series Layer 3 Stackable 10GbE Managed Switch Web UI Reference Guide Parameter Neighbor Advertisement Interval AS Origination Interval Timers Next Hop Self Send Community Soft Reconfiguration Inbound Remove Private AS Capability Graceful Restart Description EBGP Multihop Password TCP Reconnect Update Source Description Select and enter the BGP neighbor here. Options to choose from are:  IPv4 Address - Enter the IPv4 address of the BGP neighbor here.  Peer Group - Enter the name of the peer group of the BGP neighbor here. This name can be up to 16 characters long.  IPv6 Address - Enter the IPv6 address of the BGP neighbor here. Enter the advertisement interval value here. This is used to configure the minimum interval between two BGP routing UPDATE messages. The range is from 1 to 600. Select the Default option to use the default value. Enter the AS origination interval value here. This is used to configure the minimum interval between the sending of AS origination routing updates. The range is from 1 to 600. Select the Default option to use the default value. Configure the timers here.  Keep-Alive - Enter the keep-alive time value here. This specifies the time interval for sending keep-alive messages to the specified peer. The range is from 0 to 65535.  Hold Time - Enter the hold-time value here. This specifies the time interval after which a peer will be declared dead if the keep-alive messages time out. The range is from 0 to 65535. Select the Default option to use the default values. Select to enable or disable the next hop self-feature here. This is used to configure the router as the next hop for a BGP-speaking neighbor or peer group. Select to enable or disable the send community feature here. This is used to specify to send the specified type of community attributes to a BGP neighbor. Standard is used here. This specifies to send or not to send the standard community. Select to enable or disable the soft reconfiguration inbound feature here. This is used to enable the storing of the route information update from the neighbor peer. Select to enable or disable the remove private AS feature here. This is used to remove private AS numbers from the AS path list of the outbound update routes. Select to enable or disable the graceful restart capability here. This is used to enable the feature to advertise the graceful restart capability to its neighbors. Enter the description for the BGP neighbor here. This string can be up to 80 characters long. Select the Clear option to remove the description. Enter the eBGP multi-hop TTL value here. This is used to allow the router to establish a BGP session with an eBGP peer that is not directly connected to the local peer. The range is from 1 to 255. Select the Default option to use the default value. Enter the password here that will be used between two BGP peers. This can be up to 25 characters long. Select the Clear option to remove the password. Enter the TCP reconnect port number here. This is used configure the minimum interval that BGP uses to send TCP connect requests to the peer after a TCP connection failed. The range is from 1 to 65535 seconds. Select the Default option to use the default value, which is 120 seconds. Select the update source here. This is used to allow a BGP session to use any operational interface's IP address as the source address to initiate the TCP connection.  VID - Enter the VLAN ID that will be used here. The range is from 1 to 4094. 385