D-Link DXS-3610 User Manual - Page 589

DXS-3610 Series Layer 3 Stackable 10GbE Managed Switch Web UI Reference Guide Ethernet OAM Ethernet OAM Settings This window is used to display and configure the Ethernet Operations, Administration, and Maintenance (OAM) settings. To view the following window, click OAM > Ethernet OAM > Ethernet OAM Settings, as shown below: Figure 10-20 Ethernet OAM Settings Window The fields that can be configured in Ethernet OAM Settings are described below: Parameter Unit From Port - To Port State Mode Received Remote Loopback Description Select the Switch unit ID that will be used here. Select the Switch port range that will be used here. Select to enable or disable the Ethernet OAM feature on the specified port(s) here. After enabling this function on the interface, the interface will start OAM discovery. If the OAM mode of this interface is active, it initiates the discovery. Otherwise, it reacts to the discovery received from the peer. Select the Ethernet OAM mode here. Options to choose from are Active and Passive. The following two actions are allowed by ports in the active mode, but disallowed by ports in the passive mode. (1) Initiate OAM discovery. (2) Start or stop remote loopback. Select to configure the behavior of the received remote loopback requirement from the peer on the specified port(s) here. Options to choose from are:  Ignore - Specifies not to react to remote loopback requirements from a peer. 578