D-Link DXS-3610 User Manual - Page 340

DXS-3610 Series Layer 3 Stackable 10GbE Managed Switch Web UI Reference Guide The fields that can be configured are described below: Parameter Group Address/Prefix Length Source Description Enter the multicast group IPv6 address and prefix length here. Select the source to display here. Options to choose from are:  Bootstrap - Specifies to display ranges learned through the BSR.  Embedded RP - Specifies to display group ranges learned through the embedded rendezvous point (RP).  Static - Specifies to display ranges enabled by static configuration. Click the Find button to locate a specific entry based on the information entered. Click the Show All button to display all the entries. Enter a page number and click the Go button to navigate to a specific page when multiple pages exist. PIM for IPv6 Register Settings This window is used to display and configure the IPv6 PIM register settings. To view the following window, click L3 Features > IP Multicast Routing Protocol > PIM > PIM for IPv6 > PIM for IPv6 Register Settings, as shown below: Figure 6-133 PIM for IPv6 Register Settings Window The fields that can be configured in Register Checksum Whole Packet are described below: Parameter Register Checksum Whole Packet Description Select the enable or disable the register checksum whole-packet feature here. When enabled, it configures the router to calculate the checksum of register message over the entire PIM message including the data portion. By default, the register checksum methodology is PIM RFC-compliant, excluding the data portion in the Register message. Click the Apply button to accept the changes made. The fields that can be configured in Register Probe Time are described below: Parameter Register Probe Description Enter the register probe time value here. The range is from 1 to 127 seconds. The register-probe time is the time before the Register-Stop Timer (RST) expires when a DR may send a Null-Register to the RP to cause it to resend a Register-Stop message. By default, this value is 5 seconds. Select the Default option to use the default value. Click the Apply button to accept the changes made. 329