D-Link DXS-3610 User Manual - Page 579

DXS-3610 Series Layer 3 Stackable 10GbE Managed Switch Web UI Reference Guide The fields that can be configured in the table are described below: Parameter MIP Creation CCM Interval SenderID TLV MEPID List Description This option is used to configure the MIP creation for an MA. Options to choose from are:  None - Specifies not to create the MIP on ports in an MA.  Auto - Specifies that MIPs will be created on any port for this MA, when there is no MEP configured on that port for the MAs with the same VID at this MD level or any higher active MD levels, and at the same time there is an MEP configured on that port for the MA with the same VID at the next lower active MD level or there is no MA with the same VID at any lower active MD levels. For an intermediate Switch in an MA, the setting should be Auto in order for the MIPs to be created on this device.  Explicit - Specifies that MIPs will be created on any port for this MA, when there is no MEP configured on that port for the MAs with the same VID at this MD level or any higher active MD levels, and at the same time there is an MEP configured on that port for the MA with the same VID at the next lower active MD level.  Defer - Specifies to inherit the settings configured for the maintenance domain that the MA is associated with. This is the default value. Select the Continuity Check Message (CCM) interval value here. Options to choose from are 100ms, 1sec, 10sec, 1min, and 10min. An MEP will transmit a CCM packet periodically across the MA. The CCM interval indicates the interval at which CCMs are sent by a MEP in a MA. This option is used to configure the transmission of the sender ID TLV by MPs for an MA. Options to choose from are:  None - Specifies not to transmit the sender ID TLV. In the CFM hardware mode, the value is fixed to none.  Chassis - Specifies to transmit the sender ID TLV with the chassis ID information.  Manage - Specifies to transmit the sender ID TLV with the managed address information.  Chassis_Manage - Specifies to transmit the sender ID TLV with the chassis ID information and the managed address information.  Defer - Specifies to inherit the setting configured for the maintenance domain that the MA is associated with. This is the default value. Enter the Maintenance association End Point (MEP) ID contained in the MA here. The range is from 1 to 8191. Click the Apply button to accept the changes made. After clicking the Add MEP button, the following page will appear. Figure 10-5 CFM Settings (Add MA, Add MEP) Window 568