D-Link DXS-3610 User Manual - Page 618

DXS-3610 Series Layer 3 Stackable 10GbE Managed Switch Web UI Reference Guide Parameter VC VC ID Description Enter the FEC VC address here. Enter the FEC VC ID here. Click the Apply button to accept the changes made. Click the Delete button to remove an entry based on the information selected/entered. Click the Delete All button to remove all the entries associated with this feature. Enter a page number and click the Go button to navigate to a specific page when multiple pages exist. Click the Back button to return to the previous window. Ping MPLS This window is used to check the connectivity of the LSP for the specified FEC. If there is no LSP for the specified FEC, the "Destination unreachable" message will be displayed. Otherwise, MPLS echo request messages will be sent out to along with the LSP of the specified FEC. If the egress LSR received the request message, it will reply the request message sender with an MPLS echo reply message. If the sender cannot receive replies before the timeout, the "Request timed out" message will be displayed. To view the following window, click MPLS > Ping MPLS, as shown below: Figure 11-24 Ping MPLS Window The fields that can be configured are described below: Parameter IPv4 Address Mask VC VC ID Ping Times Timeout Description Select and enter the FEC IPv4 address here whose LSP connectivity will be checked. Select and enter the FEC subnet mask here. Select and enter the FEC VC IP address here. Select and enter the FEC VC ID here. Enter the ping time amount here. This is the amount of ping packets that will be sent out. The range is from 1 and 255. Enter the ping timeout value here. The range is from 1 to 99 seconds. Click the Start button to initiate the MPLS ping. 607