D-Link DXS-3610 User Manual - Page 433

DXS-3610 Series Layer 3 Stackable 10GbE Managed Switch Web UI Reference Guide The fields that can be configured are described below: Parameter Unit From Port - To Port Queue ID Rate Limit Description Select the Switch unit that will be used for this configuration here. Select the range of ports that will be used for this configuration here. Select the queue ID that will be configured here. Options to choose from are 0 to 7. Select and enter the queue rate limit settings here. Options to choose from are:  Min Bandwidth - Select and enter the minimum rate limit bandwidth value here. The range is from 8 to 100000000 Kbps. o Max Bandwidth - Enter the maximum rate limit bandwidth value here. The range is from 8 to 100000000 Kbps.  Min Percent - Select and enter the minimum rate limit percentage here. The range is from 1 to 100 percent (%). o Max Percent - Enter the maximum rate limit percentage here. The range is from 1 to 100 percent (%).  None - Select this option to remove the rate limit on the specified port(s). By default, this option is used for through all the queues on all the ports. When the minimal bandwidth is configured, the packet transmitted from the queue can be guaranteed. When the maximum bandwidth is configured, packets transmitted from the queue cannot exceed the maximum bandwidth even if the bandwidth is available. When configuring the minimal bandwidth, the aggregate of the configured minimum bandwidth must be less than 75 percent of the interface bandwidth to make sure the configured minimal bandwidth can be guaranteed. It is not necessary to set the minimum guaranteed bandwidth for the highest strict priority queue. This is because the traffic in this queue will be serviced first if the minimal bandwidth of all queues is satisfied. The configuration of this command can only be attached to a physical port but not a port-channel. That is the minimum guaranteed bandwidth of one CoS cannot be used across physical ports. Click the Apply button to accept the changes made. Advanced Settings DSCP Mutation Map This window is used to display and configure the Differentiated Services Code Point (DSCP) mutation map settings. When a packet is received by an interface, based on a DSCP mutation map, the incoming DSCP can be mutated to another DSCP immediately before any QoS operations. The DSCP mutation is helpful to integrate domains with 422