D-Link DGS-6600-48TS Configuration Guide - Page 126

Volume 3-Layer 2 Configurations / Chapter 13-MAC Address Tables Mac Address Configuration Commands Use the following command to manage the dynamic MAC address table entries on the Switch: Command clear mac address-table {dynamic [address MAC-ADDR | interface INTERFACE-ID | vlan VLAN-ID]} mac address-table aging-time SECONDS show mac address-table aging-time Explanation Clears a dynamic MAC address entry. Configures the aging time for dynamic MAC address entries. Displays the aging time settings for dynamic MAC address entries. In the following example, the user removes the MAC address "00:03:9d:75:14:21" from the dynamic address table: DGS-6600:2>enable DGS-6600:15#clear mac address-table dynamic address 00:03:9d:75:14:21 In the following example, the user sets the MAC address aging time to be 200 seconds: DGS-6600:2>enable DGS-6600:15#configure terminal DGS-6600:15(config)#mac address-table aging-time 200 DGS-6600:15(config)#end In the following example, the user displays the MAC address aging time set on the Switch: DGS-6600:2>show mac address-table aging-time Aging Time is 200 seconds DGS-6600:2> Creating Static MAC Address Entries The user can create static MAC address entries for unicast or multicast addresses. A unicast address entry is associated with a forwarding interface, but a multicast address entry can be specified with multiple forwarding interfaces. The associated interface can be a physical port or a port channel. Use the following command to create a static MAC address table entry on the Switch: Command mac address-table static MAC-ADDR vlan VLAN-ID interface INTERFACE-ID [,|-] Explanation Configures a static MAC address entry. DGS-6600 Configuration Guide 126