D-Link DGS-6600-48TS Configuration Guide - Page 531

Volume 10-Network Management / Chapter 53-Simple Network Management Protocol (SNMP) SNMP Configuring Commands In the following example the user enables the SNMP server and verifies the SNMP server has started: DGS-6600:2>enable DGS-6600:15#configure terminal DGS-6600:15(config)#snmp-server DGS-6600:15(config)#end DGS-6600:15#show snmp-server SNMP Server : Enabled System Name : core-switch Location : hq Contact : sys-admin DGS-6600:15# Figure 8-2 (below) shows inform requests between core-switch and hq Configuration for SNMP Version 1 and 2c Users SNMP v1 and SNMP v2c can run in parallel when the SNMP v3 agent is running on the system. Traditionally, SNMP v1/v2c users manage the device using the community name, with either readonly access rights or read/write access rights to all MIB objects supported by the system. Under the SNMP v3 framework, view records are used to define the set of MIB objects that are accessible to specific users. In order to easily support SNMP v1/v2c, one view record, which includes all MIB objects except for SNMP v3 related objects, is created by default. Two community strings, one for read-only access rights and one for read/write access rights, are also created by default. The following commands are used to display and configure the SNMP community string parameters: Command show snmp {community | view | group} Explanation Displays the current community string, view record, or group. DGS-6600 Configuration Guide 531