D-Link DGS-6600-48TS Configuration Guide - Page 201

Volume 4-Layer 3 Configurations / Chapter 21-IPv4 Static Route Configuration show ip route Configuration Example Command show ip route [IP-ADDRESS [/MASK] | [database] [PROTOCOL | connected | static]] Explanation Use ip route to add a static route entry. Use the no form of the command to remove a static route entry. The following is sample output from the show ip route command when entered without an address. DGS-6600:15#show ip route Codes: K - kernel, C - connected, S - static, R - RIP, B - BGP O - OSPF, IA - OSPF inter area N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2 E1 - OSPF external type 1, E2 - OSPF external type 2 i - IS-IS, L1 - IS-IS level-1, L2 - IS-IS level-2, ia - IS-IS inter area # - A number of slots are inactive * - candidate default C 2.0.0.0/8 is directly connected, vlan2 C 4.0.0.0/8 is directly connected, vlan4 S 5.0.0.0/8 [1/0] via 4.0.0.2, vlan4 S 6.0.0.0/8 [1/0] via 4.0.0.2, vlan4 Configuration Example Static Routing (IPV4) Configuration Example Create IPv4 Static routes in R1 and R2.PC2, PC3, PC4 and PC5 in different VLAN can communicate (PING) to each other. Topology Figure 21-1 Static Routing (IPv4) Configuration Topology DGS-6600 Configuration Guide 201