D-Link DGS-6600-48TS Configuration Guide - Page 159

Volume 3-Layer 2 Configurations / Chapter 15-Link Aggregation Chapter Overview important technology that can be used to aggregate bandwidth and to create resilient, redundant links, load sharing. Feature mode Static Type Mode On Table 15-1 Description On mode that places a port into an non-negotiation state. Link aggregation is forced to be formed without any LACP negotiation. Load Balancing For unicast packet, there are six algorithms to reach the load sharing. They are: • Link selection based on source MAC address • Link selection based on destination MAC address • Link selection based on source MAC address exclusive destination MAC address • Link selection based on source IP address • Link selection based on destination IP address. • Link selection based on source IP address exclusive destination IP address. For non-unicast packets, the load balance uses a difference way which is not user-configurable. • "For IP multicast packets, link selection based on destination IP address, source IP address, and source port • "For broadcast, L2 multicast and unknown (DLF) packets, link selection based on destination MAC address, source MAC address and source port Load Balance Hash Algorithm TRUNKING BASED ON SA HASHING In this mode, the device uses the source MAC address, VLAN, Ethertype and source module ID fields to hash. TRUNKING BASED ON DA HASHING In this mode, the device uses the destination MAC address, VLAN, Ethertype and source module ID fields to hash. TRUNKING BASED ON DA-SA HASHING In this mode, the device uses the destination, source MAC address, VLAN, Ethertype and source module ID fields to hash. TRUNKING BASED ON SIP HASHING In this mode, the device uses the source IP address and source port fields to hash. TRUNKING BASED ON DIP HASHING DGS-6600 Configuration Guide 159