D-Link DGS-6600-48TS Configuration Guide - Page 58

Volume 1-Configuration Fundamentals / Chapter 4-Accessing the Command Line Interface List of Constants and Default Settings NOTE: The settings specified in these commands also apply to both Telnet and SSH sessions automatically. Configuring the Terminal Timeout The Switch uses a timer to specify the amount of time a terminal session should be idle before timing out. The Switch uses the same timer for all terminal sessions, regardless of whether the session was established by a direct serial connection, a Telnet connection, or an SSH connection. To configure the amount of time the terminal session should be idle before timing out, enter the following command in privileged EXEC mode: Command terminal timeout {never | 2_minutes | 5_minutes | 10_minutes| 15_minutes} Explanation Configures the amount of time the terminal session should be idle before timing out. In the following example, the user configures an idle terminal session to time out after two minutes: DGS-6600:2>enable DGS-6600:15#terminal timeout 2_minutes List of Constants and Default Settings Constant Name Value Maximum Telnet sessions 8 Local Console Baud Rate 115200 bps Table 4-1 Constants Values Variable Name Default Value Telnet Service Enabled Telnet Service Port TCP 23 Terminal Length 24 lines Terminal Timeout Never Table 4-2 Default Variable Values DGS-6600 Configuration Guide 58