D-Link DGS-6600-48TS Configuration Guide - Page 377

Volume 5-Multiprotocol Label Switching / Chapter 35-Virtual Private Lan Services (VPLS) Configuration Examples Setting a local AC link MTU of a VPLS The follow example shows how to set local AC link MTU of a VPLS to 1000. DGS-6000:15(config)#vpls vpls100 DGS-6000:15(config-vpls)#mtu 1000 Clearing Mac Address Tables for VPLS The following example show how to clear all VPLS MAC addresses. DGS-6000:15(config)#clear mac address-table vpls dynamic The following example shows how to clear VPLS MAC address for a VPLS. DGS-6000:15(config)#clear mac address-table vpls dynamic vpls100 The following example shows how to clear VPLS MAC address for a peer of a VPLS. DGS-6000:15(config)#clear mac address-table vpls dynamic vpls100 peer 1.1.1.1 The following example shows how to clear VPLS MAC address for a local AC of a VPLS. DGS-6000:15(config)#clear mac address-table vpls dynamic vpls100 ac interface eth1.1 vlan 100 The following example shows how to clear one VPLS MAC address. DGS-6000:15(config)#clear mac address-table vpls dynamic vpls100 address 00:11:22:33:44:55 Configuration Examples MPLS - VPLS Configuration Example Configuring MPLS protocol for R1, R2 and R3. The label of MPLS is learned by LDP protocol. VPLS tunnel are established on R1 and R2. All PCs sites in a VPLS appear to be on the same Local Area Network (LAN), regardless of their locations. For example, PC1 and PC2 are at same network but connected on different sites. PC1 can communicate with PC2 through VPLS over MPLS. DGS-6600 Configuration Guide 377