D-Link DGS-6600-48TS Configuration Guide - Page 196

Volume 4-Layer 3 Configurations / Chapter 20-IPv4 Basics IPv4 Basic Configuration Commands IP Address IPv4 Basic Configuration Commands Command ip address {IP-ADDRESS SUBNET-MASK [secondary] | dhcp} Explanation Use ip address to set a primary or secondary IP address for an interface, or acquire an IP address on an interface from DHCP. Use the no form of the command to remove the IP settings configuration from the interface. This example shows how to set 10.108.1.27 as the primary address and 192.31.7.17 and 192.31.8.17 as the secondary addresses for VLAN 100. DGS6600:15#configure terminal DGS6600:15(config)#interface vlan100 DGS6600:15(config-if)#ip address 10.108.1.27 255.255.255.0 DGS6600:15(config-if)#ip address 192.31.7.17 255.255.255.0 secondary DGS6600:15(config-if)#ip address 192.31.8.17 255.255.255.0 secondary DGS6600:15(config)#end ARP Command arp IP-ADDRESS HARDWARE-ADDRESS Explanation Use this command to add a static entry in the Address Resolution Protocol (ARP) cache. Use the no arp command to remove a static entry in the ARP cache. This example shows how to add static ARP entry for a typical Ethernet host: DGS6600:15(config)#arp 10.31.7.19 0800.0900.1834 Command arp timeout SECONDS Explanation Use this command to add tp the ARP table and to set the ARP aging time for the ARP table, use the arp timeout command. This example shows how to sets the ARP timeout to 12000 seconds to allow entries to time out more quickly than the default setting: DGS6600:15(config)#interface vlan1 DGS6600:15(config-if)#arp timeout 12000 DGS-6600 Configuration Guide 196