D-Link DGS-6600-48TS Configuration Guide - Page 358

Volume 5-Multiprotocol Label Switching / Chapter 33-Multiprotocol Label Switching (MPLS) Configuration Examples Verifying the configuration Use the following command to check the MPLS relative information. This command can be used to check R1, R2 and R3. DGS-6600:15#show mpls ldp neighbor Peer : 152.170.189.152 Protocol Version : 1 Transport address : 152.170.189.152 Keep Alive Time : 30 (sec) Distribute Method : DU Loop Detect : Disabled Path vector limit : 254 Max PDU Length : 4096 Total Entries: 1 DGS-6600:15#show mpls ldp session Peer Status Role 152.170.189.152 OPERATIONAL Passive Keep Alive Distribution Mode 40 (Sec) DU Total Entries: 1 DGS-6600:15#show mpls forwarding-table LSP FEC In Label Out Label Out Interface Next Hop 1 153.170.189.0/24 - Push 53221 vlan152 152.170.189.152 2 154.170.189.0/24 - push 3 vlan152 152.170.189.152 Total Entries: 2 At the end of this configuration, PC1 (IP: 151.170.189.150/24) should be able to ping PC2 (IP: 153.170.189.150/24). MPLS (Static Label) Configuration Example Configuring MPLS protocol in R1, R2 and R3. The label of MPLS is set manually. DGS-6600 can forward the packets by these label information. PC1 and PC2 are at different network. PC1 can communicate with PC2 by MPLS Topology DGS-6600 Configuration Guide 358