D-Link DGS-6600-48TS Configuration Guide - Page 56

Volume 1-Configuration Fundamentals / Chapter 4-Accessing the Command Line Interface Terminal Settings Displaying Trusted Host Telnet Terminals The user can display a list of the hosts that are allowed to manage the Switch using a Telnet connection by entering the following command in privileged EXEC mode: Command show ip trusted-host telnet Explanation Displays a list of the hosts that are allowed to manage the Switch using a Telnet connection. In the following example, the user displays a list of the hosts that are allowed to managed the Switch using a Telnet connection: DGS-6600:15#show ip trusted-host telnet Index IP/Network Address Valid to Access 01 10.78.62.1/32 TELNET 02 10.73.87.1/32 TELNET Total Entries: 2 DGS-6600:15# Closing an Active Terminal Session An active session can be ended using either the logout, exit, or end commands. Command logout exit end Explanation Ends an active session. If the exit command is entered in EXEC mode, the active session will end. If the end command is entered in EXEC mode, the active session will end. Terminal Settings Configuring the Number of Lines Displayed on Terminal Screen The number of lines that are displayed can be changed by the user to meet their needs. The valid entries for the number of lines that can be displayed is between 0 and 512. If the user specifies a terminal length of 0, the display will continue to scroll down until the end of the display is reached. If a terminal length is specified to a value other than 0, for example 50, then the display will stop after 50 lines. Output from a single command that overflows a single display screen is followed by the -More-- prompt. At the --More-- prompt the user can use the Ctrl-C, q, or Q keys to interrupt the output and return to the prompt, press the to display an additional screen of output, or press the key to display one more line of output. DGS-6600 Configuration Guide 56