D-Link DGS-6600-48TS Configuration Guide - Page 29

Volume 1-Configuration Fundamentals / Chapter 2-Quick Start Removing and Installing Modules from the DGS-6600 Series Switch Figure 2-3 Removing and Installing Modules from the DGS-6600 Series Switch Removing Modules from the DGS-6600 • Unplug all copper/fibre cabling, i.e. RJ45 twisted-pair and fibre optic cables from the module to be removed. • Loosen and unscrew the panel's two captive screws. • Use both hands to pull the levers, on the left and right hand sides of the board, to remove the module from the DGS-6600. Installing Modules in the DGS-6604 & DGS-6608 • Remove the component card or blank panel as instructed in the section Removing Modules from the DGS-6600 • Insert the new module into the guide rail of the vacant slot. • Use the levers on the left and right hand side to push the board into position and tighten the two captive screws on the module using a straight screw driver. DGS-6600 Configuration Guide 29