D-Link DGS-6600-48TS Configuration Guide - Page 317

Volume 4-Layer 3 Configurations / Chapter 30-Border Gateway Protocol (BGP) BGP Configuration commands The following example shows you the output from a BGP routing table, using the show ip bgp command with the route-map keyword: dgs-6600:2>show ip bgp route-map RMAS1 BGP table version is 845, local router ID is 11.0.9.254 Status codes: s suppressed, d damped, h history, * valid, > best, i - internal, S Stale Origin codes: i - IGP, e -EGP, ? - incomplete Network 201.0.1.0/24 *> 201.0.2.0/24 *> 201.0.3.0/24 *> 201.0.4.0/24 Next Hop -------11.0.9.1 11.0.9.1 11.0.9.1 11.0.9.1 Metric ------ 0 0 0 0 LocPrf Weight 0 0 0 0 Path ------1701 i 1701 i 1701 i 1701 i Total Entries: 4 entries, 4 routes dgs-6600:2> Displaying the Configured Community Lists This command can be used without any arguments or keywords. If no arguments are specified, this command will display all community lists. However, the community list name can be specified when entering the show ip community-list command. This option can be useful for filtering the output of this command and verifying a single Command Syntax Use the following command in user or privileged EXEC mode to display the configured community lists: Configuration Example The following example shows you the output when using the show ip community-list command: dgs-6600:2>show ip community-list Named Community standard list C1 permit internet Named Community standard list C2 permit internet dgs-6600:2> Displaying Routes that Conform to a Specified Filter List Configuration Example To display the contents of an access-list named as-ACL_HQ: DGS-6600 Configuration Guide 317