D-Link DGS-6600-48TS Configuration Guide - Page 210
Generating a Default Route
View all D-Link DGS-6600-48TS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 210 highlights
Volume 4-Layer 3 Configurations / Chapter 22-Routing Information Protocol (RIP) RIP Configuration Commands Command key-string TEXT accept-lifetime START-TIME {infinite | END-TIME | DURATION | SECONDS} send-lifetime START-TIME {infinite | END-TIME | duration SECONDS} Explanation Specifies the authentication string that will be used with the authentication key. Specifies the start and end time for the validity of a received authentication key on a key chain. The end time can be set to a specific time, infinitely, or for a specific time duration. Specifies the start and end time for the validity of an authentication key on a key chain that will be sent. The end time can be set to a specific time, infinitely, or for a specific time duration. In the following example, the user creates a key-chain named "auth1", with a key-ID of "1". The user then creates a key-string called "forkey1string" that will be accepted from 1:30 p.m. to 3:30 p.m. and be sent from 2:00 p.m. to 3:00 p.m. The user then creates a key-string called "forkey3string" that will be accepted from 2:30 p.m. to 4:30 p.m. and be sent from 3:00 p.m. to 4:00 p.m. Finally, the user applies key-chain auth1 and to VLAN interface 406, using clear text authentication: DGS-6600:2>enable DGS-6600:15#configure terminal DGS-6600:15(config)#key chain auth1 DGS-6600:15(config-keychain)#key 1 DGS-6600:15(config-keychain-key)#key-string forkey1string DGS-6600:15(config-keychain-key)#accept-lifetime 13:30:00 Jan 25 2009 duration 7200 DGS-6600:15(config-keychain-key)#send-lifetime 14:00:00 Jan 25 2009 duration 3600 DGS-6600:15(config-keychain-key)#exit DGS-6600:15(config-keychain)#key 3 DGS-6600:15(config-keychain-key)#key-string forkey3string DGS-6600:15(config-keychain-key)#accept-lifetime 14:30:00 Jan 25 2009 duration 7200 DGS-6600:15(config-keychain-key)#send-lifetime 15:00:00 Jan 25 2009 duration 3600 DGS-6600:15(config-keychain-key)#end DGS-6600:15#configure terminal DGS-6600:15(config)#interface vlan406 DGS-6600:15(config-if)#ip rip authentication key-chain auth1 DGS-6600:15(config-if)#ip rip authentication mode text DGS-6600:15(config-if)#end Generating a Default Route The user can configure the Switch to generate a default route for RIP. The generated default route has a metric value of 1. Use the following command to automatically generate a default route for RIP: Command default-information originate Explanation Specifies that a default route will be automatically generated by RIP. DGS-6600 Configuration Guide 210