D-Link DGS-6600-48TS Configuration Guide - Page 42

Volume 1-Configuration Fundamentals / Chapter 3-Command-Line Interface (CLI) User EXEC Mode Configuration Commands Error Messages The following table explains the error messages that will appear if the user inputs a command incorrectly in the CLI: Error Message Meaning Ambiguous command Not enough keywords were entered for the Switch to recognize the command. Incomplete command The command was not entered with all the required keywords. Invalid input detected at ^ marker The command was entered incorrectly. Argument is too long The length of the command is longer than 384 characters. Users can only input an argument that is less than, or equal to 384 characters. Table 3-4 Error Messages Example of an Ambiguous Command Error In the following example, the user has typed in the word log in privileged EXEC mode. However, there are not enough letters to enable the Switch to identify if the command is login or logout. DGS-6600:15#log % Ambiguous command: DGS-6600:15# "log" Example of an Incomplete Command Error In the following example, the user has typed in the ping command in privileged EXEC mode. However, there are not enough keywords for the Switch to execute the command. DGS-6600:15#ping % Incomplete command. DGS-6600:15# Example of an Invalid Input Detected at ^ Marker Error In the following example, the user has tried to enter the shutdown command in global configuration mode. Since the shutdown command is not available in global configuration mode, the "Invalid input detected at marker" error appears in the console window, indicating the location of the error. DGS-6600:15(config)#shutdown ^ % Invalid input detected at '^' marker. DGS-6600:15(config)# DGS-6600 Configuration Guide 42