D-Link DGS-6600-48TS Configuration Guide - Page 548

Volume 10-Network Management / Chapter 55-Error Disable Port Recovery List of Constants and Default Settings In the following example, the user specifies that a port should recover from an error-disabled state after 300 seconds, if a loop-back packet is detected: dgs-6600:2>enable dgs-6600:15#configure terminal dgs-6600:15(config)#errdisable recovery interval 300 dgs-6600:15(config)#errdisable recovery cause loopback-detection dgs-6600:15(config)#end Displaying Error Disable Status The user can display the port's error disabled status. If a port is currently in the error disabled state, the reason that caused the error disabled state is also displayed. The following command is used to display the error disable status for all ports on the Switch: Command show errdisable recovery Explanation Displays the error disabled configuration. In the following example, the user displays the error disable status: dgs-6600:2>show errdisable recovery ErrDisable Reason Timer Status loopback-detection enable Timer Interval 200 seconds Interfaces that will be recovered at the next timeout: Interface Errdisable Reason Time Left(sec) eth2.4 loopback-detection 179 Total Entries:1 dgs-6600:2> List of Constants and Default Settings Variable Name Default Value Error Disable Interval 300 Seconds Error Disable Port Recovery Disabled Table 55-1 Default Variable Values DGS-8000 Configuration Guide 548