D-Link DGS-6600-48TS Configuration Guide - Page 477

Volume 8-Safeguard Engine / Chapter 47-Safeguard Engine Settings Configuration Commands Configuration Commands Commands clear cpu-protect counters [sub-interface [manage | protocol | route] | type [PROTOCOLNAME]] cpu-protect type PROTOCOL-NAME pps RATE cpu-protect safeguard threshold RISINGTHRESHOLD FALLING-THRESHOLD cpu-protect sub-interface {manage | protocol | route} pps RATE show cpu-protect safeguard show cpu-protect sub-interface {manage | protocol | route} [UNIT-ID] Description Use this command to clear the cpu-protect related counters. Use this command to configure the rate-limit of traffic destined to CPU by protocol type. Use this command to enable and configure the threshold for Safeguard Engine. Use the no form of this command to disable Safeguard Engine. Use this command to configure the rate-limit for traffic destined to CPU by subinterface type. Use this command to display the settings and status of Safeguard Engine. Use this command to show the rate-limit and statistics by sub-interface. Configuration Command Examples The following example shows how to clear all cpu-protect related statistics. DGS-6600#clear cpu-protect counters The following example shows how to set threshold of OSPF protocol packet as 100 packets per second. DGS-6600(config)#cpu-protect type ospf pps 100 The following example shows how to configure the thresholds and enable Safeguard Engine. The rising and falling threshold are 60 and 40 respectively. DGS-6600(config)#cpu-protect safeguard threshold 60 40 The following example shows how to set rate limit of manage packet group, and set threshold to 1000 packets per seconds. DGS-6600(config)# cpu-protect sub-interface manage pps 1000 DGS-6600 Configuration Guide 477