D-Link DGS-6600-48TS Configuration Guide - Page 532

Volume 10-Network Management / Chapter 53-Simple Network Management Protocol (SNMP) SNMP Configuring Commands Command snmp-server community COMMUNITY-STRING [view VIEW-NAME][ro|rw] no snmp-server community COMMUNITY-STRING Explanation Creates a new community string, specifying the access rights. The existing record "CommunityView" can be directly associated with the entry. Deletes an un-needed community string. In the following example, the user creates a read/write community string called "commaccess". The user then displays the SNMP community strings that have been configured on the Switch: DGS-6600:2>enable DGS-6600:15#configure terminal DGS-6600:15(config)#snmp-server community commaccess rw DGS-6600:15(config)#end DGS-6600:15#show snmp community codes: ro - read only, rw - ReadWrite (rw)private (ro)public (rw)commaccess Total Entries: 3 DGS-6600:15# NOTE: When a new community string is added, an entry in the user group table will be automatically created with a group name that is identical to the community string. Therefore, use the show snmp community command to display the associated MIB view settings. In the following example, the user deletes the community string called "commaccess". The user then displays the SNMP community strings to verify that the entry has been removed from the Switch: DGS-6600:2>enable DGS-6600:15#configure terminal DGS-6600:15(config)#no snmp-server community commaccess DGS-6600:15(config)#end DGS-6600:15#show snmp community codes: ro - read only, rw - ReadWrite (rw)private (ro)public Total Entries: 2 DGS-6600 Configuration Guide 532