D-Link DGS-6600-48TS Configuration Guide - Page 26

Volume 1-Configuration Fundamentals / Chapter 2-Quick Start Preparation for Installation Note: The ambient temperature and humidity should be measured at a point that is 1.5m above the floor and 0.4m in front of the equipment when there is no protective plate in the front or back of the equipment rack. Static Discharge Damage Prevention To prevent damage from static electricity, please use the following guidelines: • Be sure to install an adequate ground for all electronic equipment. • Use appropriate dust prevention measures. • Maintain the required humidity in the operating environment. • Hold circuit boards by their edges. Do not touch any components on the printed circuit board (PCB). • Always wear an anti-static wrist strap when working near any electronic circuitry. • Do not allow clothing to touch circuit boards. An antistatic wrist strap will only prevent static electricity from the human body, it will not reduce the static electricity build up on clothing. Moving the Device The DGS-6600 series Switch is quite heavy. When handling, please use the following guidelines: • Avoid moving the equipment frequently. • Seek assistance in lifting if the weight of the chassis is more then you can lift safely alone. • Lift and move the chassis using the handles on the top panel (please see Table 2-1 on page 27). • Turn off all power supplies and unplug all power cables before moving the equipment. • Completely loosen the thumb/Phillips screws and pull the card levers to remove each and all line cards, fan tray, and power modules from the chassis before moving the chassis. DGS-6600 Configuration Guide 26