D-Link DGS-6600-48TS Configuration Guide - Page 224

Volume 4-Layer 3 Configurations / Chapter 23-Open Shortest Path First (OSPF) OSPF Configuration Commands Command ip ospf transmit-delay SECONDS Explanation Specifies the estimated time that the VLAN interface will take to transmit a Link-State-Update packet. In the following example, the user configures VLAN interface 5 to have an OSPF dead interval value of 80 seconds, an OSPF hello interval value of 20 seconds, an OSPF retransmit interval value of 10 seconds, and an OSPF transmit delay value of 2 seconds: dgs-6600:2>enable dgs-6600:15#configure terminal dgs-6600:15(config)#interface vlan5 dgs-6600:15(config-if)#ip ospf dead-interval 80 dgs-6600:15(config-if)#ip ospf hello-interval 20 dgs-6600:15(config-if)#ip ospf retransmit-interval 10 dgs-6600:15(config-if)#ip ospf transmit-delay 2 dgs-6600:15(config-if)#end Configuring Area Host Route The area static host route allows the user to configure a stub host entry belonging to a particular area. The router will advertise specific stub host routes as the router-LSA for a stub link. Enter the following command to configure an area host route: Command host IP-ADDRESS area AREA-ID [cost COST] Explanation Configures an area host route. In the following example, the user defines an area host route with an IP address of 172.16.10.100 in area 1: dgs-6600:2>enable dgs-6600:15#configure terminal dgs-6600:15(config)#router ospf dgs-6600:15(config-router)#host 172.16.10.100 area 1 dgs-6600:15(config-router)#end Creating OSPF Virtual Links If a non-zero area is not physically connected to area zero, it must be connected to area zero via a virtual link. The virtual link is a point to point link through another non-zero area. The router will send OSPF messages to the neighbor router in unicast form directly to the neighbor router IP address. DGS-6600 Configuration Guide 224