D-Link DGS-6600-48TS Configuration Guide - Page 200

Volume 4 - Layer 3 Configurations IP Address Command ip address {IP-ADDRESS SUBNET-MASK [secondary] | dhcp} IPv4 Static Routing Configuration Commands Explanation Use ip address to set a primary or secondary IP address for an interface, or acquire an IP address on an interface from DHCP. Use the no form of the command to remove the IP settings configuration from the interface. This example shows how to set 10.108.1.27 as the primary address and 192.31.7.17 and 192.31.8.17 as the secondary addresses for VLAN 100. DGS6600#configure terminal DGS6600(config)#interface vlan100 DGS6600(config-if)#ip address 10.108.1.27 255.255.255.0 DGS6600(config-if)#ip address 192.31.7.17 255.255.255.0 secondary DGS6600(config-if)#ip address 192.31.8.17 255.255.255.0 secondary DGS6600(config)#end Access VLAN Command access vlan VLAN-ID Explanation Use the access vlan interface configuration command to specify the access VLAN for the interface. Use default interface command to reset to default setting. This example shows how to set an interface port 1.1 to an untagged member of VLAN 1000. DGS6600(config)# interface eth1.1 DGS6600(config-if)# access vlan 1000 Ip route Command ip route {NETWORK-PREFIX NETWORK-MASK | NETWORK-PREFIX/PREFIX-LENGTH} IPADDRESS [distance DISTANCE] Explanation Use ip route to add a static route entry. Use the no form of the command to remove a static route entry. This example shows how to add static default route entry with next-hop 10.1.1.254. DGS6600(config)#ip route 0.0.0.0/0 10.1.1.254 This example shows how to add a static route entry for a 20.0.0.0/8 with next-hop 10.1.1.254. DGS6600(config)#ip route 20.0.0.0/8 10.1.1.254 DGS-6600 Configuration Guide 200