D-Link DGS-6600-48TS Configuration Guide - Page 91

Volume 3-Layer 2 Configurations / Chapter 10-VLAN Configuration The following commands are used to create a VLAN: VLAN Configuration Commands Command vlan VLAN-ID [,|-] vlan name VLAN-NAME show vlan Explanation Used to create a VLAN or modify the attributes of a VLAN. After successfully entering this command, the Switch will enter VLAN configuration mode. Used to modify the reference name of a VLAN. Displays the VLAN settings. In the following example, the user creates a new VLAN, assigning a VLAN ID of 2 and the name "ITSupport". The user then enters the show vlan command to verify the configuration: DGS-6600:15#configure terminal DGS-6600:15(config)#vlan 2 DGS-6600:15(config-vlan)#vlan name IT-Support DGS-6600:15(config-vlan)#end DGS-6600:15#show vlan VLAN 1: Name: default GVRP advertisement: yes Static Tag Member Ports: eth4.48, Static Untag Member Ports: None GVRP Advertise Ports: eth4.1-eth4.48 Forbidden Ports: None VLAN 2: Name: IT-Support GVRP advertisement: yes Static Tag Member Ports: eth4.33, eth4.48, Static Untag Member Ports: eth4.2, GVRP Advertise Ports: eth4.1-eth4.45, port-channel5, port-channel3-port-channel4 Forbidden Ports: eth4.1, eth4.40 DGS-6600:15# Specifying an Access VLAN for an Interface An interface can only be a member of one access VLAN at any given time. When the access vlan command is applied to an interface, the interface will operate in access mode. An interface can be defined as a physical port or a port-channel. If the access vlan command is applied to a portchannel, the member ports of the port-channel will become untagged members of the access VLAN. The default VLAN ID of the port will then be changed to the VLAN ID of the access VLAN. When a port is in access mode, no trunk VLANs can be defined for the port. DGS-6600 Configuration Guide 91