D-Link DGS-6600-48TS Configuration Guide - Page 335

Volume 4-Layer 3 Configurations / Chapter 31-Policy Based Route Map (PBR) Configuration example 3. match ip address IPV4 + set ip precedence If other set clauses for policy based routing are used with the command, they will be evaluated based on the following ordering: 1. set ip next-hop 2. set interface 3. set ip default next-hop 4. set default interface with this ordering, the set next-hop clauses and the set interface clauses will be evaluated before look up of the routing table. If route cannot be found for the packets, the set ip default next-hop and set default interface command will be evaluated. Configuration example PBR Configuration Example R1 has PBR and default route. The traffic form source IP 2.x.x.x, destination IP any will direct to 7.0.0.2 (PBR) Other source IP packet will be direct to 4.0.0.2(default route) Figure 31-4 PBR Configuration Example Topology R1 Configuration steps Step 1: Create PBR route-map for PBR interface DGS-6600:15(config)#route-map PBR permit 1 DGS-6600:15(config-route-map)# match ip address PBR-match_ip4 DGS-6600:15(config-route-map)# set ip next-hop 7.0.0.2 Step 2: create vlan 2, 3, 4, 7 DGS-6600:15(config-route-map)#vlan 2 DGS-6600:15(config-vlan)#vlan 3 DGS-6600:15(config-vlan)#vlan 4 DGS-6600:15(config-vlan)#vlan 7 DGS-6600 Configuration Guide 335