D-Link DGS-6600-48TS Configuration Guide - Page 515

Volume 9-Network Application / Chapter 51-DHCPv6 Client Configuration The following example configures an upper limit of 2 hours: DHCPv6 Configurations Commands DGS-6600 > enable DGS-6600# configure terminal DGS-6600(config)# interface vlan1 DGS-6600(config-if)# ipv6 dhcp client DGS-6600(config-if)# ipv6 dhcp client information refresh minimum 7200 Configuring an IPv6 address based on an IPv6 general prefix Command ipv6 address {IPv6-ADDRESS | PREFIX-LENGTH | PREFIX-NAME SUB-BITS | PREFIX-LENGTH} Explanation Use this command to add or delete an IPv6 address on an interface. It configures an IPv6 address based on an IPv6 general prefix and enable IPv6 processing on an interface. Use the no form of this command to disable. The following example shows how to enable IPv6 processing on the interface and configure an address that is based on the general prefix called "my-prefix" and the directly specified bits: DGS-6600 > enable DGS-6600# configure terminal) DGS-6600(config)# interface vlan2 DGS-6600(config-if)# ipv6 address my-prefix 0:0:0:1::1/64 Assuming the general prefix named my-prefix has the value of 3ffe:1:2:1::1/64. if there is no general prefix named my-prefix set, no IPv6 address will be set. If the general prefix named my prefix is acquired via DHCPv6 client prefix delegation, the global address would be configured after the prefix is obtained via the DHCPv6 client. The following example shows how to remove a general prefix named my-prefix on the interface: DGS-6600 > enable DGS-6600# configure terminal DGS-6600(config)# interface vlan2 DGS-6600(config-if)# no ipv6 address my-prefix 0:0:0:1::1/64 The following example shows how to set a global address by manual configuration: DGS-6600 > enable DGS-6600# configure terminal DGS-6600(config)# interface vlan2 DGS-6600(config-if)# ipv6 address 3ffe:22:22:22::2/64 After the command is entered, the global address 3ffe:22:22:22::2/64 will be set. DGS-6600 Configuration Guide 515