D-Link DGS-6600-48TS Configuration Guide - Page 437

Volume 8-Security & Authentication / Chapter 40-802.1X Authentication 802.1X Configuration Commands Timer Description TX Period The number of seconds that the Switch will wait for a response from an EAP-Request/Identity frame before retransmitting the request. Maximum Request The maximum number of messages that can be retransmitted to the client. Table 40-1 802.1X Timer Values Enter the following commands in interface configuration mode to specify the 802.1X timers and parameters: Command dot1x timeout {quiet-period SECONDS | reauth-period SECONDS | server-timeout SECONDS | supp-timeout SECONDS | txperiod SECONDS} dot1x max-req TIMES Explanation Configures the 802.1x protocol related timers on the specified interface. Configures the maximum number of times an EAP message is retransmitted to the client. In the following example, the user sets the quiet period, reauthentication period, server timeout, supplicant timeout, and EAP request transmission period on port 4.10 to be 20, 1000, 15, 15, and 10 seconds, respectively: DGS-6600:2>enable DGS-6600:15#configure terminal DGS-6600:15(config)#interface eth4.10 DGS-6600:15(config-if)#dot1x timeout quiet-period 20 DGS-6600:15(config-if)#dot1x timeout reauth-period 1000 DGS-6600:15(config-if)#dot1x timeout server-timeout 15 DGS-6600:15(config-if)#dot1x timeout supp-timeout 15 DGS-6600:15(config-if)#dot1x timeout tx-period 10 DGS-6600:15(config-if)#end In the following example, the user specifies that an EAP message can be transmitted a maximum of 3 times on Ethernet interface 4.17: DGS-6600:2>enable DGS-6600:15#configure terminal DGS-6600:15(config)#interface eth4.17 DGS-6600:15(config-if)#dot1x max-req 3 DGS-6600:15(config-if)#end DGS-6600 Configuration Guide 437