D-Link DGS-6600-48TS Configuration Guide - Page 367

Volume 5-Multiprotocol Label Switching / Chapter 33-Multiprotocol Label Switching (MPLS) Verifying the Configuration Use following command to check the MPLS QOS mapping rules. DGS-6600:15#show mpls qos MPLS QoS Policy: policy1, Trust EXP Inbound Mapping EXP : 0, 1, 2, 3, 4, 5, 6, 7 Priority: 0, 1, 2, 3, 4, 5, 6, 6 Outbound Mapping Priority: 0, 1, 2, 3, 4, 5, 6, 7 EXP : 3, 6, 3, 3, 3, 3, 3, 3 Binding FECs: 20.0.0.0/8 Total Entries: 1 Configuration Restrictions Configuration Restrictions For support MPLS, the hardware must support label operation. In addition, L3 route and LDP shall be supported. The MPLS interface is L3 interface. LSR ID is an IPv4 address of a L3 interface. Suggest using the loop back interface address as the LSR ID. LDP is MPLS signaling protocol defined for distributing label binding information. To enable LDP, you must enable MPLS at first. The LSP establishment depends on the L3 route information. The route information can be created by route protocol or static configuration. Constant Static ILM entries Static FTN entries QoS entries Qos matched rules MPLS interface number Max Prefix FEC Max FEC number LDP Max Targeted Peer LDP Max Peer LDP Max Adjacency LDP Max Interface LDP Max LSP Trigger rules Value 16 16 256 32 64 128 2128 64 128 128 300 128 DGS-6600 Configuration Guide 367