D-Link DGS-6600-48TS Configuration Guide - Page 38

Volume 1-Configuration Fundamentals / Chapter 3-Command-Line Interface (CLI) User EXEC Mode Configuration Commands Using the End and Exit Commands The end command can be used to return to privileged EXEC mode from any configuration task in any configuration mode. If a user enters the end command while in user EXEC mode, the user will be logged out of the session. The exit command is used to end the current mode and return to the mode that the user was in previously. If the Switch is in global configuration mode, the exit command will return the Switch to privileged EXEC mode. Use the following commands to end the current configuration session or exit the current mode: Command end exit Explanation Ends the current configuration session. Exits the current mode. In the following example, the user uses the end command in interface mode to return to privileged EXEC mode: DGS-6600:15(config-if)#end DGS-6600:15# In the following example, the exit command is used in interface mode to return to global configuration mode: DGS-6600:15(config-if)#exit DGS-6600:15(config)# Help Features The help feature allows the user to get instant and interactive guidance information on using the CLI commands. The following list describes the different help features that are available on the Switch: Command ABBREVIATED-COMMAND-ENTRY? Purpose Obtains a list of commands that begin with a particular character string. For example: DGS-6600:15#di? dir List directory contents disable Turn off privileged mode command ABBREVIATED-COMMAND-ENTRY DGS-6600:15# Completes a partial command name. For example: DGS-6600:15#show spa DGS-6600:15#show spanning-tree Table 3-2 Help System DGS-6600 Configuration Guide 38