D-Link DGS-6600-48TS Configuration Guide - Page 53

Volume 1-Configuration Fundamentals / Chapter 4-Accessing the Command Line Interface Chapter Overview 6) Set flow control to hardware. 7) Under Properties, select VT100 for Emulation mode. 8) After correctly setting up the terminal, plug the power cable into the power receptacle on the back of the Switch. The boot sequence appears in the terminal. 9) After the boot sequence completes, the console login screen displays. 10) Ensure that any terminal or PC being used to make a console connection is configured to match these settings. 11) If using the USB console connection, the host will need to have the following equipment: • A terminal or a computer with USB port and the ability to emulate a terminal. • A Type A to Type B USB cable. Carry out the following to connect a terminal to the USB console port: 1) Connect the Type A connector end of the USB cable to an available USB port on the Switch. 2) Connect the Type B connector end of the USB cable to an available USB port on the computer running the terminal emulation software. Set the terminal emulation software using the same procedure described above. NOTE: If both the RS-232 and USB connection are active on the device, the USB connection will have priority over the RS-232 connection. If the device is currently being managed via the RS-232 console connection and a USB connection is established, the system will disconnect the RS-232 connection and switch over to the USB connection. If connecting to the Switch for the first time, press the key to start the login process. In the following example, the user has started a console connection and enters privileged EXEC mode: DGS-6600 Chassis-based High-Speed Switch Command Line Interface Firmware: 3.00.080 Copyright (c) 2012 D-Link Corporation. All rights reserved. DGS-6600:2>enable DGS-6600:15# DGS-6600 Configuration Guide 53