D-Link DGS-6600-48TS Configuration Guide - Page 291

Volume 4-Layer 3 Configurations / Chapter 29-IPv6 Tunneling Configuration Examples Verifying The Configuration Check R1 IPv6 tunneling 6to4 config. Use the same command, show interface tunnel1, to check other routers tables. DGS-6600:15#show interface tunnel1 tunnel1 is up, line protocol is up (connected) Hardware is Tunnel Description: inet6 2002:100:1:ffff::1/64 Tunnel source 1.0.0.1, destination UNKNOWN Tunnel protocol/transport IPv6/IP 6to4, key disabled, sequencing disabled Tunnel TTL 128 Checksumming of packets disabled, path MTU discovery disabled DGS-6600:15#show ipv6 route IPv6 Routing Table Codes: K - kernel route, C - connected, S - static, R - RIP, O - OSPF, I - IS-IS, B - BGP, X - add to ACL table fail # - A number of slots are inactive S 2002::/16 [1/0] tunnel1 C 2002:100:1::/64 is directly connected, tunnel1 Total Entries: 2 entries, 2 routes IPv6 tunneling ISATAP Configuration Example R1 is connected between IPv4 and IPv6 networks. There are two ISATAP tunnels, one is between R1 and PC1, and another is between R1 and PC2. To make two PC can communicate to IPv6 network by this tunnel. Topology Figure 29-3 IPv6 Tunneling ISATAP Configuration Example Topology Configuration Prerequisites 1. Create vlan4 and vlan6 on R1, assign an IPv4 address 10.0.0.2/8 to vlan4, assign an IPv6 address 4000:1/64 to vlan6, eth2.1 access vlan4, and eth2.3 access vlan6. DGS-6600 Configuration Guide 291