D-Link DGS-6600-48TS Configuration Guide - Page 211

Volume 4-Layer 3 Configurations / Chapter 22-Routing Information Protocol (RIP) RIP Configuration Commands In the following example, the user configures the Switch to generate a default route using the RIP routing process: DGS-6600:2>enable DGS-6600:15#configure terminal DGS-6600:15(config)#router rip DGS-6600:15(config-router)#default-information originate DGS-6600:15(config-router)#end Redistributing Routes to RIP The routes learned by other protocols such as OSPF or BGP can be redistributed to RIP. The redistributed routes will be associated with the metric specified for the redistributed protocol, or associated with the default metric if a metric is not specified by the user. Use the following commands to redistribute routes from one routing domain into another routing domain: Command redistribute PROTOCOL [metric METRIC-VALUE] default-metric METRIC-VALUE Explanation Redistributes routes from one routing domain into another routing domain. Specifies the default metric for the redistributed routes. In the following example, the user configures the Switch to redistribute OSPF routes into a RIP domain: DGS-6600:2>enable DGS-6600:15#configure terminal DGS-6600:15(config)#router rip DGS-6600:15(config-router)#redistribute ospf DGS-6600:15(config-router)#end In the following example, the user defines a default metric value of 5 for routes that were redistributed by the RIP routing protocol: DGS-6600:2>enable DGS-6600:15#configure terminal DGS-6600:15(config)#router rip DGS-6600:15(config-router)#default-metric 5 DGS-6600:15(config-router)#end DGS-6600 Configuration Guide 211