D-Link DGS-6600-48TS Configuration Guide - Page 280

Volume 4-Layer 3 Configurations / Chapter 28-Open Shortest Path First Version 3 (OSPFv3) show ipv6 ospf neighbor Configuration Examples Command show ipv6 ospf [PROCESS-ID] neighbor [IFNAME | NEIGHBOR-ID] [detail] Explanation To display IPv6 OSPF neighbor information on a per interface basis, use the show ipv6 ospf neighbor command. The following is sample output from the show ipv6 ospf neighbor command with the detail keyword. The result after executing this command is as follows. OSPFv3 Process (null) Neighbor ID Pri State Dead Time Interface 10.76.37.3 1 Full/DR 0DT0H0M33S vlan2 10.76.37.3 1 Full/ - 0DT0H0M38S VLINK1 Total Entries: 2 Instance ID 0 0 Configuration Examples OSPFv3 Configuration Example Configure two DGS-6600 to learn remote IPv6 routes via OSPFv3 protocol. In R1, routes 3005::1/64 and 3006::1/64 can be learned dynamically by OSPFv3 protocol. In R2, routes 3002::1/64 and 3003::1/64 can be learned dynamically by OSPFv3 protocol.All PCs in the topology can communicate each other by routing. Topology Figure 28-6 OSPFv3 Configuration Example Topology R1 (Router 1) Configuration Steps Step 1: create vlan 2,3,4 DGS-6600:15(config)#vlan 2 DGS-6600:15(config-vlan)#vlan 3 DGS-6600:15(config-vlan)#vlan 4 DGS-6600 Configuration Guide 280