Yamaha 01V96 Owner's Manual - Page 113
Setting Aux Out 1–8 from the Control Surface, Setting Aux Send Levels, Setting Levels, EQ settings
View all Yamaha 01V96 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 113 highlights
Setting Aux Out 1-8 from the Control Surface 113 Setting Aux Out 1-8 from the Control Surface You can use the faders, [SEL] buttons, and various buttons and controls in the SELECTED CHANNEL section on the top panel to directly control certain parameters for Aux Out 1-8. Setting Levels To set Aux Out 1-8 levels, press the [MASTER] button in the LAYER section to select the Master layer, then move faders 1-8. At this time, you can turn Aux Out 1-8 on or off using the corresponding [ON] 1-8 buttons. EQ settings To control Aux Out 1-8 EQ parameters, select the desired Aux Out (1-8) using the corresponding [SEL] button or fader, then use the buttons and controls in the SELECTED CHANNEL section. The parameters on this page (and the procedure for setting them) are the same as for Input Channels (see page 83). Setting Aux Send Levels You can adjust the level of signals routed from Input Channels to the corresponding Aux Out (1-8). 9 Setting Send Levels from the Display Aux Outs You can view multiple channels' Aux Send levels on the screen and adjust them individually. 1 Press the FADER MODE [AUX 1]-[AUX 8] buttons to select the Aux. 2 Make sure that the 01V96 displays the Aux | Send page. This page enables you to adjust the level of the signals routed from each Input Channel to the Aux selected in Step 1. If the Send page is not displayed, repeatedly press the button that you pressed in Step 1 until the Send page appears. • Aux Send rotary controls These controls adjust the Aux Send level of the Input Channels. The current numeric levels appear below the rotary controls. • PRE/POST These buttons enable you to specify the Aux signal source points. The PRE buttons send pre-fader signals, and the POST buttons send post-fader signals. 01V96-Owner's Manual