Yamaha 01V96 Owner's Manual - Page 77

Input Channels 77 7 Input Channels This chapter describes how to adjust the 01V96's Input Channel parameters. About Input Channels The input Channel section enables you to adjust the level and tone of the signals input to the 01V96 (and the signals output from the internal Effects processors 1-4), and route the signals to Buses 1-8, the Stereo Bus, and Aux Sends 1-8. There are two types of Input Channels, each featuring slightly different functions: monaural Input Channels 1-32 and stereo ST IN Channels 1-4. Input Channels 1-32 Each of these monaural Input Channels features a phase effect, gate, compressor, attenuator, and EQ for signal processing. The following diagram illustrates the Input Channel 1-32 7 signal flow. INPUT 1(...32) INPUT PATCH BUS1 BUS2 BUS3 BUS4 BUS5 BUS6 BUS7 BUS8 STEREO L STEREO R SOLO L SOLO R AUX 1 AUX 8 Input Channels (Gain Reduction) METER (Out Meter) METER GATE ATT Keyin 12ch Group(1-12,13-24....) AUX 1-8 METER INSERT 4BAND EQ INPUT DELAY METER SOLO INSERT ON LEVEL PAN PAN (Gain Reduction) (Out Meter) METER METER COMP LFE PRE/POST ON AUX Keyin Self or Stereo Link DIRECT OUT 1(...32) Input Channels 1-32 feature the following parameters: • (Phase) This section switches the phase of input signals. • GATE This dynamics processor can be used as a gate or for ducking. • COMP (Compressor) This dynamics processor can be used as compressor, expander or limiter. The compressor can be pre-EQ, pre-fader, or post-fader. • ATT (Attenuator) This section enables you to attenuate or amplify the level of signals that will be input to the EQ. The attenuator enables you to prevent post-EQ signals from clipping and to correct signal levels that are too low. • 4 BAND EQ (4-band equalizer) This parametric EQ features four bands (high, high-mid, low-mid, and low). • INPUT DELAY (Input delay) This section enables you to delay input signals. You can use this delay to fine-tune the timing between channels, or as a delay effect with feedback. 01V96-Owner's Manual