Yamaha 01V96 Owner's Manual - Page 97

Bus Outs 97 8 Bus Outs This chapter describes how to adjust the 01V96's Stereo Out and Bus Out 1-8 parameters. About Stereo Out The Stereo Out section receives Input Channel and Bus Out 1-8 signals, mixes them into two channels, processes them using on-board EQ, compressor, etc., then routes them to the STEREO OUT and 2TR OUT connectors. The following diagram illustrates the Stereo Out signal flow. STEREO L STEREO R (Gain Reduction) (Out Meter) METER METER COMP INSERT ATT METER 4BAND EQ INSERT ON INSERT LEVEL BAL OUTPUT DELAY METER DA Same as stereo master L DA L (-10dBV) [2TR OUT] R L (+4dBu) [STEREO OUT] R 8 OUTPUT PATCH Bus Outs • INSERT This section enables you to route the Stereo Out signals to external devices via the on-board connectors or I/O card, or insert internal effects processors. • ATT (Attenuator) This section enables you to attenuate or amplify the level of signals to be input to the EQ. The attenuator prevents post-EQ signals from clipping or corrects signal levels that are too low. • 4 BAND EQ (4-band equalizer) This parametric EQ features four bands (HIGH, HIGH-MID, LOW-MID, and LOW). • COMP (Compressor) This dynamics processor can be used as compressor, expander, or limiter. The processor can be located pre-EQ, pre-[STEREO] fader, or post-[STEREO] fader. • ON (On/Off) This button turns the Stereo Out on or off. • LEVEL The [STEREO] fader adjusts the Stereo Out output levels. • Balance This section enables you to adjust the level balance between the L and R channels of the Stereo Out. • OUTPUT DELAY (Output delay) This section delays the output signals. It is mainly used to fine-tune the signal timing. 01V96-Owner's Manual