Yamaha 01V96 Owner's Manual - Page 94
Naming Input Channels, Press the DISPLAY ACCESS [PATCH] button repeatedly until the Patch |
View all Yamaha 01V96 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 94 highlights
94 Chapter 7-Input Channels When you switch the Pair Mode, the combinations of channel numbers displayed on the page also change. Note: • When Pair mode is switched, only the channel numbers change. The mix parameters of the paired partners do not change. • For example, if you change Pair mode from Horizontal to Vertical, the Input Channel "2" indication changes to Input Channel "17." However, its parameters do not change. (If Channels 1 and 2 have been paired, switching the mode will pair Channels 1 and 17.) 3 Move the cursor to the desired channel's MONOx2 button (2), then press [ENTER]. The channels are paired. 4 To cancel a pair, move the cursor to the desired channel's STEREO button, then press [ENTER]. Tip: You can also create or cancel a pair of Output Channels in the same way on the Pair/Grup | Output page (see page 105). Naming Input Channels By default, Input Channels are named CH1, CH2, etc. You can change these names if desired. For example, it may be helpful for mixdown if you name a particular Input Channel with the type of musical instrument connected to the corresponding input jack. 1 Press the DISPLAY ACCESS [PATCH] button repeatedly until the Patch | IN Name page appears. 1 2 3 You can specify Short names in the center column (1) and Long (full) names in the right column (2). When the Name Input Auto Copy check box (3) is on, the first four characters of a newly-entered Long name are automatically copied to the Short name. On the other hand, a newly-entered Short name is automatically added to the beginning of the Long name. You can reset all channel names to their default names by moving the cursor to the INITIALIZE button, then pressing [ENTER]. 01V96-Owner's Manual